Product Description
V-Groove Shiplap for measured wall layouts
The V-Groove Shiplap creates a defined nickel-gap surface. Use the verified profile details below to plan orientation, repeated spacing and the finished edges of the installation.
Verified profile details
Available in MDF and solid wood (connect with us about which species you are looking for). MDF comes primed. Size: 5 11/16-inch (height) x 19/32-inch (depth)
Plan orientation and termination points
Decide whether the profile runs horizontally or vertically before calculating quantities. Mark inside and outside corners, openings, outlets, switches and the points where the treatment meets baseboard, casing or crown moulding.
Estimate coverage from the visible layout
Measure each wall separately and plan full pieces around the most visible areas first. Confirm the usable face or repeat of the selected profile, then include a project-appropriate allowance for cuts, joints and pattern alignment. Keep offcuts assigned to shorter sections where the layout allows.
Confirm material, finish and installation conditions
Verify the supplied material and finish condition before installation planning. Confirm the substrate, room conditions, fastening method and required perimeter clearances with the installer, and use a current sample where colour, grain or sheen must coordinate with adjoining surfaces.
Compare wall-panel options
Browse more wall panels and accent-wall profiles or coordinate the treatment with trim and mouldings.
